How to load a plastic film sprial

This is an outline on how to load a film spiral ready for processing.

The only way to learn is to practice feeding a film onto a spiral in day light. I suggest purchasing a cheap roll of 35mm film, probably colour. It is also a good idea to have a brand new spiral to practice with. This should make the learning curve less steep as older spirals get temperamental the more they have been used.

Prepare the film: You can use a cassette opener or film retriever for 35mm. Once you have the leader/tongue of the film in view use a pair of scissors to cut it square. Then snip the corner off each side, the film is now ready for loading.

Now lay out everything you need on a table in daylight for a complete dummy run. Set the developing tank, lid, spiral with center in place and scissors out in the same order each time to get a picture in your mind's eye, this way you will know where everything is in the dark. Keep the film in your hand. With your eyes closed load the film on the spiral, place it in the developing tank, put the lid on and turn till it clicks shut. Some tanks have a screw top so be careful not to cross thread it. After a few practices you maybe ready to do it for real.

Note: Make sure your hands are clean and dry. Damp or sweaty fingers can cause problems with the loading of the film and leave marks on the processed negatives. It is a good idea to wear soft cotton gloves for protection.

Tip: If you wash your hands in cold water before you start it closes the pores reducing the need for gloves. It is also a good idea to earth yourself on a radiator to stop charging the film with static electricity therefore attracting dust. 

It is a lot easier to do than it sounds, so don't be put off. Everyone has their own way of doing this so if you have a tip to add please do.

This video gives a straight forward no-nonsense look at how it is done.